Orange Pi Alarm System GPIO terminal block

gfucka

Hi, I'm new in the OrangePi world.

I want create an alarm system with Orange Pi so I need to connect to GPIO pins the wire from the PIR sensors.
I'm finding ad andapter or extension for GPIO to have terminal block like this on the Orange Pi GPIO:
http://www.lkw-navigator.de/image_db/FleetPC-GPIO.jpg

so I can connect easy all wires.

Please can you help me to find an adapter or say me if there is some alternative way.

Thank you so much...

gfucka

Please someone answer me. Thank you

less

we use these to connect between GPIO and whichever size of terminal block / breadboard we require:


the other end of the cable leading to a block, such as this:

gfucka

Thank you for tour andare. I will try your solution. So you cut the wire on one end and put It on one side of terminal block? The female end go to the GPIO pin. It is correct?

less

yup, that is correct. Some of the cables (easily to be found on your favorite online shop with electronics) sell the other end just lose cable (no connector), so you got one end with with the female connector that goes to the GPIO pin and the other end goes to the block.

gfucka

Thank you so much. You save me a lot of time and searchs!! Thanks

shocksguide

An alarm system is a crucial component of security for both residential and commercial properties. It serves as a deterrent to potential intruders while also providing peace of mind to occupants. Typically, an alarm system consists of sensors placed strategically throughout the property, such as on doors, windows, and in key areas.  fire protection contractors in Raleigh