GPIO library - WiringPi

domcat · Published in 2016-2-28 20:54:10

@WereCatf
I recompile the kernel with sysfs interface enabled (loboris distro), disable gpio_sunxi module at start up and everything works.

Now my OPI is perfetct

thank you very much...

apocalyps · Published in 2016-3-2 05:42:42

Oke everything works perfectly

root@orangepipc:~/433Utils/RPi_utils# ./codesend 12345679
sending code[12345679]
root@orangepipc:~/433Utils/RPi_utils# ./RFSniffer
Received 12345679

Copy code

apocalyps · Published in 2016-3-6 00:30:53

@werecatf: Can you take a look at support for https://github.com/wiringX/wiringX on orange pi. Its similar to wiringpi but only supports bananapi

WereCatf · Published in 2016-3-6 03:50:54

apocalyps replied at 2016-3-6 00:30
@werecatf: Can you take a look at support for https://github.com/wiringX/wiringX on orange pi. Its s ...

I can add it to my wishlist, but I'm slow at getting anything done and I've been busy with trying to improve Armbian and building stuff with ESP8266's and such, and I'm going on a holiday with my boyfriend in a couple of weeks, so.. well, don't expect anything to happen for some time. And I'm not promising to do it, I'll only promise to take a look and maybe do it

apocalyps · Published in 2016-3-6 05:20:23

My programming skills are not sufficient enough for this but i think that it shouldnt be much work. WiringX tries to detect if the hardware is supported so for bananapi there allready is a specials detect file. I think it needs a little adjustment so i hope you have some spare time left somewhere

melanrz · Published in 2016-3-7 20:30:51

domcat replied at 2016-2-28 20:54
@WereCatf
I recompile the kernel with sysfs interface enabled (loboris distro), disable gpio_sunxi m ...

can you upload kernel and uimage?

apocalyps · Published in 2016-3-8 01:28:30

why dont you just install armbian

melanrz · Published in 2016-3-8 09:25:20

lubuntu working 3 time faster

StaLeWaR29 · Published in 2016-3-14 14:55:01

@WereCatf

I use your code from post #70.
But I have a problem when it is used.

I run the code once - all works fine. I stop code using Ctrl-C.
When I run the code a second time - it does not work. Do not considers pulses.

he re-works if to make gpio unexport 16
how to free the PIN in a code?

WereCatf · Published in 2016-3-14 15:31:11

StaLeWaR29 replied at 2016-3-14 14:55
@WereCatf

I use your code from post #70.

My OPi PC is dead so I cannot test this, but I just pushed a quick-and-dirty commit to WiringOP that should fix the issue. If you would be so kind as to get the latest WiringOP from https://github.com/WereCatf/WiringOP.git and testing it, then letting me know if works or not?