OrangePI-2 Android 4.4.2 New Image

garyang · Published in 2015-7-5 12:43:46

loboris replied at 2015-7-4 22:44
If you successfully downloaded the file from that link, could you upload it to some place where I ...

https://drive.google.com/file/d/ ... kE/view?usp=sharing

I've uploaded my google drive.

loboris · Published in 2015-7-6 00:25:11

Edited by loboris at 2015-7-6 00:27

NEW image based on E7II-H3-8189-20150702_V2 ROM uploaded.
Thanks @garyang, @ivanelbigfoot for link.
Works better than previous, wifi, ethernet, usb, youtube ....
Download opi2_lobo_Android_v2.img.xz from Mega.

Freliix · Published in 2015-7-6 12:20:44

loboris replied at 2015-7-6 00:25
NEW image based on E7II-H3-8189-20150702_V2 ROM uploaded.
Thanks @garyang, @ivanelbigfoot for link.
...

Hello friend, with that software edits the firmware of OP?

loboris · Published in 2015-7-6 15:03:15

Freliix replied at 2015-7-6 12:20
Hello friend, with that software edits the firmware of OP?

imgRePacker, some edits, moving, testing ...

bob2005 · Published in 2015-7-7 01:41:56

Not loaded. I waited 20 minutes. Processor is very hot!

bob2005 · Published in 2015-7-7 01:43:25

shows "smart your life"

loboris · Published in 2015-7-7 02:54:58

bob2005 replied at 2015-7-7 01:41
Not loaded. I waited 20 minutes. Processor is very hot!

To check, I've just downloaded the file from Mega, unpacked it, checked md5 and burned sd card with PhoenixCard v3.1.
OPI-2 booted without problem, "smart your life" is shown for about 20 sec, then boot animation and launcher screen.
So the image is OK, probably you have error in download or burn process.

matteobp · Published in 2015-7-7 15:39:32

I have Orange Pi Plus. I can confirm that the image is ok. You have to burn it with PhoenixCard v3.1, and with startup option set.
I did few tests.

USB port and wi-fi works fine.
I didn't test ethernet and youtube (I hope I can try it later).
Cannot play h265 video and some h264 video.

matteobp · Published in 2015-7-7 15:54:10

Another strange behavior. I attached a fan to the 5V SATA power, and it works with all other images, including the one in the EMMC. But when I use this Android image, there is no power. I tested it also with a multimeter. 0V, no power. Is it controlled by software?

loboris · Published in 2015-7-7 19:20:14

@matteobp
H265 video examples (1080p and some 4K) from elecard plays without problem in MX Player.
SATA Power is software controlled and this image is created with OPI-2 fex, so SATA (and SATA power) probably does not work.
I'll upload the image created with OPI-PLUS fex soon.
You can use 5V from expansion port (pins 2 or 4, pin 6 GND).