Edited by ayaromenok at 2019-1-2 18:16
it's a 5MP camera, which connected to Dsiplay and not a board itself
-
http://www.orangepi.org/orangepibbsen/forum.php?mod=viewthread&tid=3868quote:
Moreover I think that standard MIPI-CSI Cameras are 30 pins!!!
it is NO standard for MIPI-CSI - only electrical signals(but can be different supported frequency). also camera cable include power lines and control line(I2C usually) - so number of lines all together can be different. Some cameras can be compatible electrically, but not compatible mechanically (like RPI cams - need passive adapter), some can be compatible mechanically and electrically, but require different settings in kernel(like signal lines 0 and 1 switched), some not compatible electrically and mechanically, but may work via not-trivial adapter(like RPI cam(3.3V) and 30x0.5mm connector(no 3.3V power, but can be gathered from GPIO pin)), and some not compatible at all(DPV and CSI camera - different data transfer, but may use similar connector)
for example, even raspberry-pi use 3 different types:
1) 2CSI lines/15x1mm (RPI 1,2,3) (official RPI cam v1 & V2)
2) 4CSI lines/22x0.5mm (PI Zero & RPI Compute module - I/O board - CSI0) (compatible with #1 by usage only 1&2 lines)
3) 2CSI lines/22x0.5mm(RPI Compute module - I/O board - CSI0) - can be connected to #1 vie passive cable adapter.
