login|Register
Forum > Interfacing
Post|
看5236|回2|Favorite
techcap 看全部
2019-2-1 10:15:12
On Orange Pi Zero, there are two pull-up resistor, R153, R154. Why is it used the external pull-up resistors? If we use internal pull-up, we may use these ports for multiple purpose.

I want to use this port for controlling relay. After boot-up, this value is high so activated my relay.
Can I configure it down maually on boot stage?
Nadalia 看全部
2022-9-21 12:46:36

I am looking for the same solution on a Zero 2.
Did you ever manage to set the resistors on your Zero?

asstuctuc 看全部
2022-12-9 12:29:14
I came to this site with the introduction of a friend around me  and I was very impressed when I found your writing. I'll come back often after bookmarking!  majorsite

OrangePi En

Powered by Discuz! X3.4

homepage|Simple edition|Touch edition|PC