sACN E1.31 Pixel controller 4 Universes

dmx512

I am happy to announce the sACN E1.31 Pixel controller 4 Universes.

It is open source (https://github.com/vanvught/rpidmx512) and open hardware (https://github.com/vanvught/h3dmx512-zip/tree/master/eagle).

Supported addressable leds: WS2801, WS2811, WS2812, WS2812B, WS2813, WS2815, SK6812 (RGBW), APA102, APA102C

I have successfully tested the firmware with MadMapper, Jinx!, QLC+ and sACNView. Where MadMapper is using the E1.31 Synchronization Packet, this setup is great for large installation.

The open source code runs on the Allwinner H2+ SoC which can be found in the supported board: Orange Pi Zero

Firmware download -> https://github.com/vanvught/h3dmx512-zip

Website -> http://www.orangepi-dmx.org/raspberry-pi-e131-bridge

charlly

sACN is a great way to control lots of pixels. A single sACN E1.31 controller can control up to 4 universes of pixels,  diamonds rings near me  which is a lot of light! This makes sACN a great choice for large shows and events.