Edited by yeyeto2788 at 2015-9-15 07:15

Hi guys, I'm not an expert in linux that is why I need your help.

Yesterday I worked with the OPi Mini 2 and take some screenshots of the OS and data and so on, but today I wanted to configure the wifi dongle and it was imposible since I can not see anything on any video output.

I tried AV output and nothing then HDMI output and also nothing so I thought probably I made something wrong shutting down the OPi but I also try making a new fresh image on other SD card and guess what....NOTHING.

I dig on my electronic stuff and found a USB-TTL converter to plug it on the OPi and below you will see the output I got. It stuck there for hour and nothing else. It is still waiting for a video signal and waiting for finishing to boot up.

HELP!!!!!

-------------------------------
I will put the code on the reply.
POSSIBLE ANSWER

Hi! I think that the problem could be the SD card.


I used the same kind of SD card on a Raspberry Pi 2 and today I had a problem on booting the Raspberry Pi as I had with the OPi. While I was waiting for the RasPi 2 to get it boot up I plugged the OPi to see if for some miracle it could work and guess what... IT'S WORKING AGAIN.


I supposed it is the SD card. I'm posting a picture od the SD card I'm using.

I thought I could use any card as long as it is 8GB and at least class 4. Has anyone and idea why maybe the SD card would fail?

This is the last part of the output from the serial port.

Here is the complete code on a .pdf file.

ma be truble here
hub 1-0:1.0: 1 port detected
sunxi-ehci sunxi-ehci.2: SW USB2.0 'Enhanced' Host Controller (EHCI) Driver
sunxi-ehci sunxi-ehci.2: new USB bus registered, assigned bus number 2
sunxi-ehci sunxi-ehci.2: irq 106, io mem 0xf1c1b000
sunxi-ehci sunxi-ehci.2: USB 0.0 started, EHCI 1.00
ehci_irq: highspeed device connect

How can I solve the problem? I have just the keyboard and the HDMI cable plugged in.