please choosego to mobile | Continue to access the PC version
View: 3958|Reply: 3

how to fix a burned orangepi one

[Copy link]

1

threads

3

posts

23

credits

Novice

Rank: 1

credits
23
Published in 2021-1-11 04:03:23 | Show all floors |Read mode
Hi guys.
i did a stupid move by powering my usb hub pluged on orangepi with my dc adapter set to 9v insted of 5v XD.
it is not working anymore.(armdian buster)
i have green d7 on, and both rj45ligth on.

i check some of the compenemt but found nothing.
do you know a way to troubleshoot it? can i monitor boot with tx rx pin or other way?


1

threads

3

posts

23

credits

Novice

Rank: 1

credits
23
 Author| Published in 2021-1-11 21:17:27 | Show all floors

1

threads

3

posts

23

credits

Novice

Rank: 1

credits
23
 Author| Published in 2021-1-11 22:29:41 | Show all floors
after serial communication i found that boot stop at the begining

  1. U-Boot SPL 2020.10-armbian (Jan 05 2021 - 02:13:45 +0100)
  2. DRAM:
Copy code

1

threads

24

posts

105

credits

Registered member

Rank: 2

credits
105
Published in 2021-1-17 20:37:17 | Show all floors
I think it may be damaged beyond repair, but power off  and leave it a few hours
to make absolutely sure no residual charge exists.

If you can check your sd card in another linux system run a filesystem check to make
sure card is ok.

On my Orange Pi zero  with no card and power applied I get ethernet LEDS lit and no green
power light. With a bootable sd card the green power light comes on after 2 or 3 seconds and loads normally.

I think though this is perhaps damaged beyond repair.
You need to log in before you can reply login | Register

Points Rule

Quick reply Top Return list