LUBUNTU No memory space error 看全部

On installing lubuntu on Only 500mb of free space is left on for file system which runs out of memory on installing other application.
How can i expand the file system or what is the solution ? I have 12GB of remaining unallocated space How can i make it use for file system.

There's this magic thing called parted. Look it up (you CAN alternatively use fdisk too, btw)
  • Bench guyc
  • 2017-1-30 23:44:21
I have the same problem. SD 16 gb, but OP PC2 only sees 4gb.
I followed the installation procedure for the orangePI PC because could not find one for the orangepi PC2
Can someone explain step by step ( I'm completely new with this stuff) how I can use the full memory card ?

At this moment I cannot load any program because no memory space.
  • Floor guyc
  • 2017-1-31 01:32:29
I tested the SD-card in my linuxmint PC.  Here is can see 15,5 gB with the instruction : sudo fdisk -l

Disk /dev/mmcblk0: 15.5 GB, 15523119104 bytes
4 koppen, 16 sectoren/spoor, 473728 cilinders, totaal 30318592 sectoren
Eenheid = sectoren van 1 * 512 = 512 bytes
Sectorgrootte (logischl/fysiek): 512 bytes / 512 bytes
in-/uitvoergrootte (minimaal/optimaal): 512 bytes / 512 bytes

Schijf-ID: 0x000ebed2

      Apparaat Opstart   Begin       Einde     Blokken   ID  Systeem
/dev/mmcblk0p1           40960      143359       51200    c  W95 FAT32 (LBA)
/dev/mmcblk0p2          143360     7395327     3625984   83  Linux

When I do the same with the SD-card in the OP PC2, I receive as result :
Disk /dev/mmcblk0: 14.5 GB, 15523119104 bytes
Device                    Boot  start       End Sectors                size         ID   Type
/dev/mmcblk0p1           40960      143359      102400      50MB     c    W95 FAT32 (LBA)
/dev/mmcblk0p2          143360     7395327    7251968    3,5MB   83  Linux

I looks, something is wrong in the OP from the orangepi PC2. As said in my previous post, I used the orangepi PC quick start guide because there is no quick start guide for the OPPC2 available on the website.
Have you solved the problem already?

starting lubuntu for the first time, you can enter the following command.

$ sudo fs_resize
$ sudo reboot

The /dev/mmcblk0p2 area is expanded by rebooting.
Update software after rebooting.