I am having problems getting my Orange Pi Plus to boot...
   
    I am using a good quality 5v regulated PSU with capacity of better    than 2.5A
    I am using a TV as HDMI monitor
    I have tried separate USB mouse / keyboard and USB wireless keyboard
    I have tried several class 4 and class 10 TF cards of 8Gb capacity
    I have tried Lubuntu and Raspbian for the Orange Pi Plus downloaded    from http://www.orangepi.org/downloadresources/
    I have configured the TF cards following the guide on http://www.orangepi.org/quickstart/    using both Windows and Linux
   
    Having setup and inserted the TF card, connected the monitor    keyboard and mouse, then applied power to the board all I get is a    solid RED LED lit on the main board, and nothing on the monitor.
   
    I have extensive experience with both the Raspberry Pi and Banana    Pi, both of which I have had no problem getting to work. All of the ancillary hardware has been tested using both a Raspberry Pi and Banana Pi without problem...
   
    Can you please advise if there is anything I should try...
   
    Regards,
   
        Si.


   

Don't use the 'official' downloads but those from loboris instead. And where do you supply power?

Hi power is being applied to the 2.5x5.5mm power connector...

Shall try the Loboris software next...

Have loaded OrangePI_Jessie_Xfce.img from the recommended site, following LINUX based instructions found there to set up the TF card.

Alas the results seem to be no better than before, just a solid red light and nothing on the display...

Any more suggestions?

Regards, Si.