|
|
Hello,
I tried to use Armbian & Debian with orange pi +2E, OS work fine ! 
When i connect my UART-to-RS485 module to any of UART GPIOs (UART1,UART2 or UART3) it is work fine until i reboot my Opi +2E board, it lockups at boot (no LED is active and display output with no signal)
Until i disconnect RX pin of my module.
I'm using the following module:
is there any suggested solution ?? 
|
This thread contains more resources
You need to Log in to download or view，No account?
Register
x
|
Show IP Card
Radar Card
Published in 2018-4-18 20:04:12
Bump Card
Stick Card
Silent card
Open Thread Card
Highlighter card
Jack
Anonimous Post