|
|
Hi,
we are trying to use raspberry hat with 3xUART on orange 3B board.
On the official page UART9 uses pins 7(TX) and 29(RX) of GPIO header (40pins) which is compartible with Rpi.
However finally it turns out that TX not on pin 7 but on pin 22.
At orange3B wiki page there two different confusing screenshots (the are below) regarding the piout.
In one TX is on pin 7 on other on pin 22.
Could you please help to understand how to configure pins to use in 7 as TX for UART9?
|
|
Show IP Card
Radar Card
Published in 2024-2-23 20:46:46
Bump Card
Stick Card
Silent card
Open Thread Card
Highlighter card
Jack
Anonimous Post