|
Hi,
I want use 4 TB sata disk on orange pi plus 2. But I could not use because of orange pi plus 2 dont know it correctly.
Orange pi plus 2 see, 2 TB instead of 4 TB like as;
Disk /dev/sda: 1.7 TiB, 1801763772416 bytes, 3519069868 sectors
[ 2.640845] scsi 0:0:0:0: Direct-Access ST4000LM 016-1N2170 0009 PQ: 0 ANSI: 0
[ 2.642564] sd 0:0:0:0: [sda] 3519069868 512-byte logical blocks: (1.80 TB/1.63 TiB)
[ 2.643582] sd 0:0:0:0: [sda] Write Protect is off
[ 2.643599] sd 0:0:0:0: [sda] Mode Sense: 03 00 00 00
[ 2.644653] sd 0:0:0:0: [sda] No Caching mode page found
[ 2.644667] sd 0:0:0:0: [sda] Assuming drive cache: write through
[ 2.648018] sd 0:0:0:0: [sda] No Caching mode page found
[ 2.648032] sd 0:0:0:0: [sda] Assuming drive cache: write through
[ 2.679655] sda: unknown partition table
[ 2.682941] sd 0:0:0:0: [sda] No Caching mode page found
[ 2.682962] sd 0:0:0:0: [sda] Assuming drive cache: write through
[ 2.682980] sd 0:0:0:0: [sda] Attached SCSI disk
But it should be(i test it on bananapi);
Disk /dev/sda: 3.7 TiB, 4000787030016 bytes, 7814037168 sectors
[ 2.229797] sd 0:0:0:0: [sda] 7814037168 512-byte logical blocks: (4.00 TB/3.63 TiB)
[ 2.241803] sd 0:0:0:0: [sda] 4096-byte physical blocks
[ 2.251081] sd 0:0:0:0: [sda] Write Protect is off
[ 2.380451] sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00
[ 2.419335] sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[ 2.665622] sda: sda1
[ 2.681321] sd 0:0:0:0: [sda] Attached SCSI disk
Probably firmware dont support more then 2TB hard disk.
orangepi plus 2 have a new firmware?
Or how can i solve this problem?
Thanks.
|
|