please choose
go to mobile
|
Continue to access the PC version
Add to favorites
|
Orangepi
Turn on secondary access
login
|
Register
search
search
Hot search:
orangepi
this forum
Threads
Users
Forum
BBS
My Center
OrangePi
»
Forum
›
Using the Orange Pi Series
›
Troubleshooting
›
How to enable spi interface for orange pi winplus sb ...
Return to list
View:
4411
|
Reply:
0
How to enable spi interface for orange pi winplus sbc
[Copy link]
ironmantis7x
ironmantis7x
Offline
credits
29
Show IP Card
Radar Card
5
threads
5
posts
29
credits
Novice
Novice, integral 29, For the next level needed 21 integral
Novice, integral 29, For the next level needed 21 integral
credits
29
Send PM
Published in 2019-6-4 09:12:23
|
Show all floors
|
Read mode
I have a waveshare 10.1 inch hdmi touch panel and an Orange pi winplus a64 SBC.
I want to activate the spi interface and attach the orange pi winplus to the waveshare 10.1 inch display via the 26 gpio pins.
I have turned on the spi and ic21 and ic20 interfaces in armbian-config.
However, the display says "No Signal" when I try to use the spi interface with the display.
I referenced this tutorial as a guide:
https://unix.stackexchange.com/q ... fd2a2664996399b3fed
And this documentation as well:
https://docs.armbian.com/Hardware_Allwinner_overlays/
am not getting something quite right as the orange pi doesnt recognize the display.
https://github.com/armbian/sunxi-DT-overlays/tree/master/examples
I need to figure out what I need to do.
Do I need a .dots overlay file as well?
Reply
Use magic
report
Bump Card
Stick Card
Silent card
Open Thread Card
Highlighter card
Jack
Anonimous Post
Return to list
Advanced mode
B
Color
Image
Link
Quote
Code
Smilies
You need to log in before you can reply
login
|
Register
Points Rule
Reply
Jump to the last page after replying
Quick reply
Top
Return list