6,556
edits
Changes
no edit summary
Run this after unzip: DriverInstall.exe<br>
In order to use the latest driver of all device, please first click Drive unload and then click Drive install:<br>
<div style="padding-left:200px ;">[[File:Orange-pi-rk3399-img7.png|400px|]]</div>
<br>
Connect with Type-C data cable and PC with Orange Pi RK3399 after installed USB driver, there would be show the status of USB driver on lower right corner like the following:<br>
<br>
<div style="padding-left:200px ;">[[File:Orange-pi-rk3399-img8.png|300px|]]</div>
<br>
'''2)Enter into Flashing Mode'''
* Press on Recovery key of Orange Pi RK3399
* Type-C Connect to Orange Pi RK3399, there should be notice on the following :
<div style="padding-left:200px ;">[[File:Orange-pi-rk3399-img9.png|400px|]]</div>
<br>
There would be log information if you connect debug pin.<br>
<br>
<div style="padding-left:200px ;">[[File:Orange-pi-rk3399-img10.png|400px|]]</div>
<br>
If there is no Loader device, then you need to flash image with short connect like the following:<br>
When short connect EMMC Clk and GND, insert DC power supply, enter into Maskrom mode. And insert Type-C cable to connect both PC and RK3399.<br>
Location of EMMC Clk is show on the following:
<div style="padding-left:200px ;">[[File:Orange-pi-rk3399-img11.png|800px|]]</div>
<br>
<div style="padding-left:200px ;">[[File:Orange-pi-rk3399-img12.png|800px|]]</div>
<br>
* Insert DC power supply<br>
Since OrangePi RK3399 supports powered by TypeC, power voltage on USB of PC is enough for flashing image. However, it may not enough to support Orange Pi booting. In that case, we need to insert DC power supply to make sure the Orange Pi could boot successfully after flashed image.
* If need to flash every partition image(*.img) separately, right click Download Image then click corresponding firmware path. After that click Run, and the right side would show the status of running.
<div style="padding-left:200px ;">[[File:Orange-pi-rk3399-img13.png|800px|]]</div>
<br>
* If need to flash unity firmware(update.img), click Firmware on Upgrade Firmware, select path of update.img. After it recognized LOADER device, click Upgrade and it will begin to upgrade. The right side would show the status of flashing.
<div style="padding-left:200px ;">[[File:Orange-pi-rk3399-img14.png|800px|]]</div>
<br>
=== '''Flashing image on Linux''' ===
Since OrangePi RK3399 supports powered by TypeC, power voltage on USB of PC is enough for flashing image. However, it may not enough to support Orange Pi booting. In that case, we need to insert DC power supply to make sure the Orange Pi could boot successfully after flashed image.<br>
There would be log information if you connect debug pin.
<div style="padding-left:200px ;">[[File:Orange-pi-rk3399-img10.png|400px|]]</div>
<br>
If there is no Loader device, then you need to flash image with short connect like the following:
