8,367
edits
Changes
→How to use E-Key PCIe WIFI6+Bluetooth module
<li><p>Then insert the module into the M.2 E-Key interface of the development board and fix it. The position is shown in the figure below:</p>
<p>[[File:plus5-img233.png]]</p></li>
<li><p>Then open use the configuration '''lspci''' command, if you can see the information of the WIFI module in the Linux system, it means that the steps are as follows:module is in good contact</p>
<ol style="list-style-type: lower-alpha;">
<li><p>First run '''orangepi-config''', normal users remember to add '''sudo''' permissionAX200 displays as follows</p>
{| class="wikitable" style="width:800px;"
|-
|
<p>orangepi@orangepi:~$ '''sudo orangepi-configlspci | grep "Network"'''</p><p>0002:21:00.0 Network controller: Intel Corporation Wi-Fi 6 AX200 (rev 1a)</p>
|}
</li>
<li><p>Then select '''System'''AX210 displays as follows</p><p>[[File{| class="wikitable" style="width:plus5800px;" |-img234.png]]</p></li><li>|<p>Then select orangepi@orangepi:~$ '''Hardwarelspci | grep "Network"'''</p><p>[[File0002:21:00.0 Network controller:plus5Intel Corporation Wi-img235.png]]Fi 6 AX210/AX211/AX411 160MHz (rev 1a)</p>|}</li><li><p>Then use the arrow keys of the keyboard to navigate to the position RTL8852 display as shown in the figure below, and then use the space to select the '''wifi-pcie''' configuration</p><p>[[File{| class="wikitable" style="width:plus5800px;" |-img236.png]]</p></li><li>|<p>Then select orangepi@orangepi:~$ '''<Save>lspci | grep "Network"''' to save</p><p>[[File0002:21:plus5-img23700.png]]</p></li><li><p>Then select '''<Back>'''</p><p>[[File0 Network controller:plus5Intel Corporation Wi-img238.png]]Fi 6 AX200 (rev 1a)</p></li><li><p>Then select '''<Reboot>''' to restart the system to make the configuration take effect</p>|}<p>[[File:plus5-img239.png]]</p></li></ol>
</li>
<li><p>If everything is normal after restarting the system, Then use the following command to see that there will be an additional WIFI device node. If you can't see it, please check if there is any problem with the previous configuration</p>
{| class="wikitable" style="width:800px;"
|-
|
<p>[orangepi@orangepi ~]$ '''ip addr showa'''</p>
|}
</li>
