Changes

iv. After the image is written, click "close" button<br><br>'''5)Write Android image into EMMC'''<br><br>Steps for writing image into EMMC is almost the same with writing into TF card.<br><br>a.Download corresponding Android image and Phoenix Card writing tool.<br>b.Formatting SD card.<br>c.Make sure the Disk is same as TF card, and start formatting SD card.<br>d.Write Android into TF card, please note the red mark, which is differentfrom writing into TF card.<br><br><div style="padding-left:200px;">[[文件:Orange-pi-pc2plus-img212e-img2.png|600px|]]</div><br>After written image with Card production, then exit.<br><br>e.Power it on, you could found that the red LED on board is flashing which means the image is writing. When the red LED off, image written finished. Take off the TF card, then power the board on, it should run.<br>

iv'''6)Write Linux image into EMMC'''<br><br>It is same of H3 serial for image writing into EMMC. In this charter would take Plus 2E as an example to illustrate which just need to install_to_emmc.<br>a. Official website image<br>$ sudo install_to_emmc<br>Enter Y to make sure data in emmc has been erased<div style="padding-left:200px;">[[文件:Orange-pi-plus-2e-img3.png|400px|]]</div><br>After finished writing into EMMC, take SD card off and it will boot from EMMC.<div style="padding-left:200px;">[[文件:Orange-pi-plus-2e-img4.png|400px|]]</div><br>b.Armbian image<br>$ sudo nand-sata-install<div style="padding-left:200px;">[[文件:Orange-pi-plus-2e-img5.png|400px|]]</div><br>Select OK<div style="padding-left:200px;">[[文件:Orange-pi-plus-2e-img6.png|400px|]]</div><br>Select EXT4 as the format of the image is written, click <div style="padding-left:200px;">[[文件:Orange-pi-plus-2e-img7.png|400px|]]</div><br>Formatting partition<div style="closepadding-left:200px;" button>[[文件:Orange-pi-plus-2e-img8.png|400px|]]</div><br>Wait image writing to EMMC.<div style="padding-left:200px;">[[文件:Orange-pi-plus-2e-img9.png|400px|]]</div>