|
Edited by and_rivne at 2020-11-2 16:30
Hello all !
I connected relle to pins (Physical):
- Relle Orange
- in 35
- gnd 6
- ucc 2
Copy code
But it is constantly active (on), although the port status 32 is off (0).
Why is that?
![](http://dl3.joxi.net/drive/2020/11/02/0020/1392/1373552/52/574425a4c1.jpg)
Changes the port status, but has no effect on the relay. Relle ist ON alweys!
![](http://dl4.joxi.net/drive/2020/11/02/0020/1392/1373552/52/4cb7553705.jpg)
If you physically disable the pin (in - 35), then the relay is turned off.
Maybe I need to configure something in the system to activate the GPIO?
I use Orange PI Lite
|
|