|
Hi,
I also tried the latest OpenELEC build from 2016/8/6 on my opi PC. It did start as jernej saw from my console log. I'm using an HDMI to DVI cable may be this is a reason. I manually wanted to change the display settings (like armbian script h3disp is doing), but at the moment I worry a bit....
I took power off after ~5 minutes because H3 is getting extremely hot. Meanwhile I got a heatsink (bought from Kolbers.de), so the CPU is protected a bit. Anyway, temperature ware continuously increasing starting from 53 degrees to 69. Then I took power off.
Some log:
OpenELEC:~ # cat /sys/devices/system/cpu/cpu0/cpufreq/cpuinfo_max_freq
1296000
OpenELEC:~ # cat /sys/devices/system/cpu/cpu0/cpufreq/cpuinfo_cur_freq
480000
OpenELEC:~ # cat /sys/devices/virtual/thermal/thermal_zone0/temp
68
OpenELEC:~ # cat /sys/devices/virtual/thermal/thermal_zone0/temp
70
I have not seen this issue with the latest armbian. I'll go back to armbian as long as there will be a next OpenELEC image, where I could try it again. But I can provide more information, if needed.
Best Regards
mk_munich |
|